Configure the physical interface.
Remap controls, banks, LEDs, and power behavior over class-compliant USB MIDI. Zero drivers — flash-ready firmware updates included.
Connection
First time? Connect the controller directly by USB, choose Connect Device, then select its MIDI endpoint. Chrome or Edge may ask for MIDI permission. See the setup guide if it is not listed.
Get firmware release notes
Receive an email when stable firmware, beta features, and important controller updates are available.
Global defaults
Choose the fallback MIDI channel. When the device supports per-control settings, each control can override this default.
Apply and save
Apply Changes lasts until restart. Save Permanently keeps the settings after the controller is unplugged or restarted. Keyboard shortcuts: Ctrl/⌘ + Enter to apply and Ctrl/⌘ + S to save.
Configuration files
Download a portable backup of every setting and bank, or load one into the editor. Loading a file does not change the controller until you choose Apply Changes or Save Permanently.
Analog knobs and sensors
Per-knob CC control, pitch bend, filtering, split CC, and joystick
modes. Use Center-Return for joysticks
(potentiometer or hall-effect). Radar distance controls can map
proximity to CC or Pitch Bend. Sensor hardware type is set in
firmware (config.h). Output range maps the entire
calibrated physical travel to the chosen minimum and maximum.
Default LED state colors
These colors are the fallback for addressable LEDs. Copy a color pair here or from any button LED, then paste it wherever needed.
LED assignments
This endpoint does not report configurable LEDs.
Bank switching
Bank switching is not enabled on this device.
Power management
This device does not report deep sleep support.
Firmware update
Firmware updates require a supported USB MIDI connection. If you are configuring over Bluetooth, reconnect the controller by USB to install firmware.
MIDI monitor and diagnostics
Live channel messages from the connected board, plus SysEx traffic for link and firmware debugging.