Open the interface
- Use Chrome, Edge, or Opera.
- Open /configure.html.
- Click Connect Device and grant MIDI access.
- Select the MIDI endpoint if more than one appears.
Bluetooth configuration (2.5 beta)
Firmware 2.5 beta can use the same configurator over Bluetooth MIDI. First pair the controller in your operating system’s Bluetooth MIDI setup. If the system exposes it as a MIDI endpoint, open the beta configurator and select the wireless endpoint. Apply, save, refresh, bank, LED, and configuration-file operations use the same SysEx protocol as USB.
Browser and operating-system BLE MIDI support varies. Firmware installation is deliberately unavailable over Bluetooth; reconnect by USB before opening the Firmware tab.
Sections (tabs)
| Tab | Purpose |
|---|---|
| Overview | Channel, LED colors, harmony, deploy actions |
| Buttons | Note / CC / PC map, latch, enable, custom harmony stacks |
| Knobs | EC11 rotary actions, CC, pitch bend, filter, split, joystick modes |
| LEDs | Per-button pressed/released colors and traditional LED mapping |
| Banks | Alternate maps behind a bank select control |
| Power | Deep sleep trigger + inactivity timeout |
| Firmware | USB MIDI .bin field update |
| Monitor | SysEx serial log |
Deploy semantics
| Action | Behavior |
|---|---|
| Apply Changes | Writes config to device RAM (immediate effect) |
| Save Permanently | Applies and saves settings so they survive a power cycle |
| Refresh | Re-reads config from device |
| Factory Reset | Restores firmware defaults |
Save Permanently automatically applies the editor’s current values first. Use Apply Changes when you want to test a mapping without committing it to flash.